Question

A network engineer needs to configure MCP in Cisco ACI so that it begins generating syslog messages after 60 seconds upon receiving 10 continuous looped packets. Which set of actions achieves this objective?

Accepted Answer

A. Disable loop protection action.Set initial delay to 60.Set Loop Detect Multiplication Factor to 10.

Answer

Enable loop protection action.Set initial delay to 60.Set Loop Detect Multiplication Factor to 10.

Answer

Disable loop protection action.Set initial delay to 60.Set Transmission Frequency to 10.

Answer

Enable loop protection action.Set initial delay to 60.Set Transmission Frequency to 10.