Q5Site-to-site Virtual Private Networks on Routers and Firewalls
Refer to the exhibit. What does this command set configure?
← → navigate · a answer
Community votes
Discussion · 12
6
Correct answer is C.
The configuration snippet is an exact match to the server configuration when you check it. Not the client.
4
C is the correct answer, this is FLEXVPN
server configuration
3
the correct answer is C
3
i also think it's C
C 2
Selected Answer: C
C , under authorization policy there is IPv6 pool to assign IPs to client.
2
correct answer is C
1
C is the only one that makes sense. Also, the pool configuration is always done in the hub or "server" https://www.cisco.com/c/en/us/support/docs/security/flexvpn/116528-config-flexvpn-00.html
1
Answer C is correct.
This output shows an FlexVPN server for an IPv6 dynamic Virtual Tunnel Interfaces (dVTI) session.
this output comes from here:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_ike2vpn/configuration/xe-16-11/sec-flex-vpn-xe-16-11-book/sec-cfg-flex-serv.html#GUID-DB69AED1-1068-4700-B837-5F2967CCD9D2
1
image copied from this configuration: https://content.cisco.com/chapter.sjs?uri=/searchable/chapter/content/en/us/td/docs/ios-xml/ios/sec_conn_ike2vpn/configuration/xe-16-9/sec-flex-vpn-xe-16-9-book/sec-cfg-flex-serv.html.xml
1
Correct answer is C
C 1
Selected Answer: C
Flex VPN vonfig
1
Why don't Exam Topics correct these answers? In 300-730 there are more than 30% of them wrong. That is unacceptable.