Q29Network Access Device Administration
Which interface-level command is required to enable 802.1X authentication?
← → navigate · a answer
Community votes
Discussion · 6
3
dot1x system-auth-control= do it globally on the whole switch
and PAE do it only on interface
2
It says "Interface-level", thus PAE
B 2
Selected Answer: B
B is correct - PAE authenticator on the interface--dot1x system-auth-control in GLOBAL CONFIG
1
I thought for some reason this should be dot1x system-auth-control since the question didn't mention anything about PAE?
B 1
Selected Answer: B
dot1x PAE is for interface-level configuration
B 1
Selected Answer: B
This example shows how to turn on 802.1X and AAA on Fast Ethernet port 2/1, and how to check the configuration:
Switch# configure terminal
Switch(config)# dot1x system-auth-control
Switch(config)# aaa new-model
Switch(config)# aaa authentication dot1x default group radius
Switch(config)# interface fastethernet2/1
Switch(config-if)# switchport mode access
Switch(config-if)# dot1x pae authenticator
Switch(config-if)# dot1x port-control auto
Switch(config)# end