ETExamTower
Sign in
Q5Architecture and Deployment

What is the purpose of the `ip http server` command on a switch?

← → navigate · a answer
Community votes
D
83% (5)
A
17% (1)
B
0% (0)
C
0% (0)
Discussion · 13
14
I believe this correct answer should be D : https://www.packetmischief.ca/2012/02/09/cisco-ise-and-ip-http-server/
3
Correct answer is D.
3
correct answer is D but the question is written in a poor way...
3
the Purpose as the questions mentioned is to redirect users for web authentication. the correct answer is D
D 3
Selected Answer: D It's the DDDDDDDDD For Mab you use command :Mab on NAD
3
Answer is D. If you missed this, stop here and go back to study.
D 3
Selected Answer: D D, lets it redirect
2
D is correct
D 2
Selected Answer: D D is required for web redirect
D 2
Selected Answer: D D is correct
A 1
Selected Answer: A The purpose of the ip http server command on a switch is to enable the https server for users for web authentication. This means that when a user connects to the switch, they are redirected to a web page where they can enter their username and password. If the username and password are correct, the user will be granted access to the network. The other options are incorrect. dot1x authentication is a type of Layer 2 authentication that uses 802.1X. It is not enabled by the ip http server command. MAB authentication is a type of Layer 2 authentication that uses MAC addresses. It is not enabled by the ip http server command. The switch does not redirect users for web authentication. The user is redirected to the web page by the switch's HTTP server.
1
Total mess. Correct is D, not A. The command mentioned in the question enables the switch to redirect endpoints to the CWA portal.
1
D) SISE ebook: "Enable the Switch HTTP/HTTPS Server The embedded HTTP/HTTPS server in IOS is used to capture HTTP traffic from the user and redirect that user’s browser to the Centralized Web Authentication portal or to a device registration portal or even to the mobile device management onboarding portal. This same function is used for redirecting the posture agent’s traffic to the Policy Services node. Follow these steps to enable the switch HTTP/HTTPS server: Step 1. Enable the HTTP server by entering the following command in global configuration mode: C3850(config)# ip http server Step 2. Enable the HTTP secure server by entering the following command: C3850(config)# ip http secure-server"