No transcoding is needed here, since there is no need to convert codecs; instead, interworking from SIP to H.323 and vice-versa is needed for the signaling.

Answer should be A.

Selected Answer: A By default, Expressway functions as a SIP–H.323 and H.323–SIP gateway, but only if at least one of the endpoints involved in the call is locally registered. You can change this setting so that Expressway acts as a SIP–H.323 gateway regardless of whether the endpoints involved are locally registered. You also have the option to disable interworking completely. The options for the H.323 <-> SIP interworking mode are: • Off: The Expressway does not act as a SIP–H.323 gateway. • Registered only: The Expressway acts as a SIP–H.323 gateway but only if at least one of the endpoints is locally registered. • On: The Expressway acts as a SIP–H.323 gateway regardless of whether the endpoints are locally registered. https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/expressway/admin_guide/X14-0-2/exwy_b_cisco-expressway-administrator-guide-x1402.pdf

B. Transcoding in Cisco Unified Communications Manager. Using g.711 codec internally and 729 externally.

Answer is A. Interworking to convert between SIP and H323

Interworking - interworking is required on expressway seriers to interwork h.323 to SIP calls. CUCM is SIP only and does not support H.323 calls. Inteworking for B2B calls is always done at expressway level

Selected Answer: A It should be A

Selected Answer: A Answer: A

Selected Answer: A It is A

Correct answer is A. Interworking on Expressway-C

Please change the correct answer to A.

The answer is Ajavascript:void(0)