The answer is D: vEdge1# show omp tlocs --------------------------------------------------- tloc entries for 10.4.0.1 mpls ipsec --------------------------------------------------- RECEIVED FROM: peer 10.100.0.12 status C,I,R loss-reason not set lost-to-peer not set lost-to-path-id not set Attributes: attribute-type installed encap-key not set encap-proto 0 encap-spi 256 encap-auth sha1-hmac,ah-sha1-hmac encap-encrypt aes256 public-ip 172.31.14.2 public-port 12346 private-ip 172.31.14.2 private-port 12346

correct..

B should be the correct one , as it shows tloc and color information

B is not correct for this answer because the actual command is show omp routes not show omp route. So D should be the correct answer since it is the full command. This can be checked on this page. https://www.cisco.com/c/en/us/td/docs/routers/sdwan/command/sdwan-cr-book/operational-cmd.html#r_show_omp_tlocs_1923.xml

There isn't a correct answer actually: sdwn01# show omp tlocs detail (this is showing you learned colors) --------------------------------------------------- tloc entries for 1.1.1.2 biz-internet ipsec --------------------------------------------------- RECEIVED FROM: peer 0.0.0.0 uslav-colo-1fdc-sdwn01# show omp tlocs (not showing you colors) PUBLIC PRIVATE PSEUDO PUBLIC PRIVATE PUBLIC IPV6 PRIVATE IPV6 BFD FROM PEER STATUS KEY PUBLIC IP PORT PRIVATE IP PORT IPV6 PORT IPV6 PORT STATUS -------------------------------------------------------------------------------------------------------------------------------- 0.0.0.0 C,Red,R 1 1.1.1.1 12387 1.1.1.1 12387 :: 0 :: 0 up

If you run show omp tlocs like shown in the example, it doesn't show the color. Show OMP route does, although that's not the command without the S but it works. I couldn't add a screen shot of show omp tlocs output, but it's shown in the example below and you can see there is no color label.

I made a mistake on this one: the font was so big the screen wrapped and wasn't displsaying the color and tloc details. I thought something was wrong.. I'd agree show omp tlocs is the right answer here....D

Speirsington's comment below shows the show omp tlocs command, and you can see that it does show the color.

Selected Answer: D D is Correct #show omp tlocs | tab will give the color information because it is in a table format