ETExamTower
Sign in
Q46Network

Refer to the exhibit. An engineer needs to monitor ingress traffic from the SW1 and SW2 port-channel interfaces on SW3. Which configuration must be implemented to achieve this goal?

Question exhibitQuestion exhibitQuestion exhibitQuestion exhibitQuestion exhibit
← → navigate · a answer
Community votes
B
100% (3)
A
0% (0)
C
0% (0)
D
0% (0)
Discussion · 3
3
B is correct since the ingress traffic (traffic received from SW1 and SW2) must be the source interface on SW3: SW3# configure terminal SW3(config)# monitor session 2 SW3(config-monitor)# source interface port-channel 1 rx SW3(config-monitor)# source interface port-channel 2 rx SW3(config)# interface ethernet 1/4 SW3(config-if)# switchport monitor SW3(config-if)# exit SW3(config)# monitor session 2 SW3(config-monitor)# destination interface ethernet 1/4
B 2
Selected Answer: B B: because it's the only choice that sets a destination interface inside the created monitor session, which satisfies the request
B 1
Selected Answer: B B is the correct answer!