ETExamTower
Sign in
Q17Network

A network engineer must configure FCoE on an interface of a Cisco MDS 9000 Series Switch. It must map VLAN 600 to VLAN 6. Drag the commands into their correct implementation order for the FCoE configuration. Some commands are not used. <DragDrop items={["vsan 6 bind interface vfc 6","allowed vlan 1,600","allowed vlan 1","vsan 6 interface vfc 6","fcoe vsan 6","bind vsan 6"]} slots={[{"answer":"fcoe vsan 6","id":"blank1"},{"answer":"allowed vlan 1,600","id":"blank2"},{"answer":"vsan 6 interface vfc 6","id":"blank3"}]} template={"switch(config)# vlan 600\nswitch(config-vlan)# {{blank1}}\nswitch(config)# interface ethernet 1/2\nswitch(config-if)# switchport mode trunk\nswitch(config-if)# switchport trunk {{blank2}}\nswitch(config-if)# spanning-tree port type edge trunk\nswitch(config)# interface vfc 6\nswitch(config-if)# bind interface ethernet 1/2\nswitch(config)# vsan database\nswitch(config-vsan)# {{blank3}}"} explanation={"Cisco MDS maps an FCoE VLAN to a VSAN under VLAN configuration with `fcoe vsan <vsan-id>`. The Ethernet interface carrying FCoE traffic must permit the FCoE VLAN on its trunk, here VLAN 600 (with VLAN 1 also allowed as specified). The VFC interface is then added to VSAN 6 with `vsan 6 interface vfc 6` in VSAN database configuration."} reuse={false} />

← → navigate · a answer
Discussion · 1
5
The answer looks correct. Example: Mapping VSANs to VLANs The following example shows how to configure the FCoE VLAN and a virtual Fibre Channel interface: Step 1 Enable the related VLAN and map the VLAN to a VSAN. switch(config)# vlan 200 switch(config-vlan)# fcoe vsan 200 switch(config-vlan)# exit Step 2 Configure the VLAN on a physical Ethernet interface. switch# configure terminal switch(config)# interface ethernet 1/4 switch(config-if)# spanning-tree port type edge trunk switch(config-if)# switchport mode trunk switch(config-if)# switchport trunk allowed vlan 1,200 switch(config-if)# exit Step 3 Create a virtual Fibre Channel interface and bind it to a physical Ethernet interface. switch(config)# interface vfc 4 switch(config-if)# bind interface ethernet 1/4 By default, all virtual Fibre Channel interfaces are on VSAN 1. If the VLAN to VSAN mapping is to a VSAN other than VSAN 1, then continue with Step 4. Note Step 4 Associate the virtual Fibre Channel interface with the VSAN. switch(config)# vsan database switch(config-vsan)# vsan 200 interface vfc 4 switch(config-vsan)# exit