350-401 question 94: Refer to the exhibit. An engineer needs to prevent VLAN 20 routes f…

Q83Infrastructure

Refer to the exhibit. An engineer needs to prevent VLAN 20 routes from appearing in the routing table on Switch-1. Which command set must be applied?

← → navigate · a answer

Community votes

100% (3)

0% (0)

Discussion · 3

D 8

Selected Answer: D This setup applies an inbound distribute-list on Switch-1 for OSPF, blocking routes from the specified network (192.168.2.0/24).

This question is also not appropriate: all OSPF routes will no longer show up in the SW1 routing table. don't forget the implicit deny in the ACL. Too many Cisco exam questions are awful.

D 2

Selected Answer: D D is correct but there is supposed to be "permit any"