PoE monitoring and policing compares the power consumption on ports with the administrative maximum value (either a configured maximum value or the port’s default value). If the power consumption on a monitored port exceeds the administrative maximum value, the following actions occur: • A syslog message is issued. • The monitored port is shut down and error-disabled. • The allocated power is freed.

I suppose A is the correct answer if the port in question has NOT Classification Override enabled. I found the article below in several Cisco pages but couldnt tell what exaclty enabling Classification Override does and confirm what you shared here. Inline Power IEEE Power Classification Override At this point, Im wondering if the question has a flaw in the sentence.

A is correct

None of the answers are correct. Option 'a' is definitely NOT correct. The device isn't configured for PoE monitoring and policing mode - we are told it is configured for power classification override. So, the switch is set to ignore the power consumption information provided by the PD and instead allocate a fixed amount of power to the port. This is not the outcome described in the option.

Selected Answer: A My answer was A. Still, the wording of the question was a little confusing.

Selected Answer: A Power classification override : https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/15-4SY/config_guide/sup6T/15_3_sy_swcg_6T/power_over_ethernet.html#80693

The correct action taken by a switch port enabled for PoE power classification override is: D. If a switch decides that a device is using less than the minimum configured power, it assumes the device has failed and disconnects it. This feature lets power distribution on PoE ports be better managed by making sure that only devices drawing an adequate amount of power stay connected.

Selected Answer: D According to chat GPT the answer is D. ChatGPT says why A is NOT the answer as follows: "This is a possible outcome, but it applies to situations where the power exceeds the maximum configured value, not specifically to power classification override behavior."

Selected Answer: A https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/power_over_ethernet.pdf - Page 4 Wording/Attention check. In this case you need to pay attention to the answers and how they are worded. (question is a distraction)

Selected Answer: A It is the only consequence of overpower

Selected Answer: A The answer is A.

Selected Answer: A This is my best guess. I think I agree with the others.