Q93IP Connectivity
You are configuring an edge router interface with a public IP address for Internet connectivity. The router must obtain the IP address dynamically from the service provider. Which command is required on interface FastEthernet 0/0 to accomplish this?
← → navigate · a answer
Community votes
Discussion · 11
21
D is correct, which means the router will work as a DHCP client.
If a router should be configured as a DHCP server, the commands are as follows:
conf t
service dhcp
ip dhcp pool <pool name>
network <network to be use as pool>
default-router <default gateway or the ip address of the ethernet interface facing the host>
dns-server <ip add of your dns server, say: 8.8.8.8 which is a google dns>
exit
8
think you may have mistaken where your answers are. ip address dhcp is answer D.
7
D is the answer
R1(config)#int Gi0/0
R1(config-if)#ip address dhcp
3
Not correct, check again. The answer is C.
R1(config)#int Gi0/0
R1(config-if)#ip address dhcp
2
D is correct.
2
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_dhcp/configuration/15-sy/dhcp-15-sy-book/config-dhcp-client.html
1
right answer
1
I am sure I have seen "ip address dynamic or negotiate" somewhere? Anyway I chose dhcp which is correct.
1
D. ip address dhcp
To get an IP address dynamically from a service provider for Internet connectivity, you would use the "ip address dhcp" command on the interface. This command tells the router to request an IP address from a DHCP (Dynamic Host Configuration Protocol) server, which is usually provided by the Internet service provider (ISP). DHCP is a method for devices to automatically receive network configuration settings, including IP addresses, from a central server.
1
Agree. D is correct.
D 1
Selected Answer: D
D is correct, that would mean router need to place its interface in client mode for DHCP.