Q47Network Access
Refer to the exhibit. An engineer needs to configure GigabitEthernet1/1 to support both voice and data traffic. Which configuration achieves this task?
← → navigate · a answer
Community votes
Discussion · 16
13
VoIP phones work in a strange way. The access port is split into two ports, one for voice and one for data. So somehow the access access port acts like a trunk.
5
It is a trunk but not set up as a trunk. Voice VLANS are weird.
https://networklessons.com/cisco/ccna-routing-switching-icnd1-100-105/voice-vlan
4
The answer is 'A'.
For some people, this may be confusing since the port has to be enabled as a trunk port to carry different kinds of data/two vlans.
but Voice VLAN config is an exception, although we may need to config it as trunk, we are doing it as an access port only. the access port itself acts as trunk port
This is an exception.
3
How can this be correct? Access ports can only handle one vlan per port.
A 3
Selected Answer: A
PAGE198, VOL1;
Example 8-8 Configuring the Voice and Data VLAN on Ports Connected to Phones
3
A is correct
A 3
Selected Answer: A
Correct
2
Guys, how can a access port handle two different Vlans over the same interface, not convinced with the ans.
A 2
Selected Answer: A
Voice VLANs work like this.
A 2
Selected Answer: A
https://study-ccna.com/configuring-voice-vlans/
1
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_40_se/configuration/guide/scg/swvoip.pdf
A 1
Selected Answer: A
For some people this may be confusing and it might be the first time around until i looked at the answer more clearly. The answer is A, because lets say you wanted to configure the port as a management port, you would want to configure that interface first before the voice vlan. Thats the only thing I remember from working with switching as an administrator
D 1
Selected Answer: D
D: You need to enable protected management frame under the SSID configured
1
A indeed
1
A is correct
1
A is correct
VoIP concept