Wrong, in D answer you are setting the range in access; to create ethercannel we need mode trunk .... i tried to research on my netacad course. In this case i'll go A.

Selected Answer: A LACP uses active and passive A. Uses active(2 active interfaces do form ether channel) Correct Answer B. Uses passive(2 passive interfaces don't form ether channel) C. Uses desirable (This is for PAGP ether channel required is LACP) D. Uses mode on(This is for static ether channel required is LACP)

You are dead wrong. A is correct.

Selected Answer: D I would think answer D... because...they ask the question on both switched. If you "mode active" on both sides it won't form the etherchannel. If "mode ON" then it would establish the channel? Am I wrong?

Selected Answer: A LACP - Active & Passive - Active forms with Active hence A , note LACP & PAGP can be either Trunk or Access ports

Selected Answer: A Passive P/ Active A / On mod O P+P =No trunk / P+ A = trunk / P+ O = no trunk A+P =trunk / A+A =trunk / A +O = no trunk O+P = no t / O+A= no trunk / O+O =trunk

Selected Answer: A It's A. Active and Active is LACP Desirable and Desirable is PAGP

Selected Answer: A A is correct

It should be Interface range G1/1-G1/3, assume it is typo.

for option A they picked trunk config which is not complete ,maybe the other switch its not using dot1q so the best answer is D

mode ON is not part of LACP, not dynamic. correct answer is A.

Selected Answer: A active mode, starts the negotiation to build the EtherChannel. mode DES is part of PAgP mode ON is (static, not dynamic which LACP is for) mode ACCESS is for host, not trunk