Q45Security Fundamentals
Refer to the exhibit. A network administrator must allow traffic from the `10.10.0.0/24` subnet to the WAN on interface `Serial0`. What is the effect of this configuration when the administrator applies the command?
← → navigate · a answer
Community votes
Discussion · 19
C 36
Selected Answer: C
The permit command does not fail; it is syntactically valid even though the ACL would not work as intended because it would not allow traffic from the 10.10.0.0/24 subnet. The answer is C because ip access-list 10 in is not a valid command and is rejected. The correct command would be ip access-group 10 in.
11
Answer is B. ip access-list is not a valid command. ip access-group is required
C 5
Selected Answer: C
With interfaces
ip access-group is used
with VTY lines
ip access-class is used
access-list <number/name> in/out is an invalid command, the router will not apply the access list and will return an error message
C 4
Selected Answer: C
The correct answer is C. The router will fail to apply the ACL to the Serial interface because it doesn't use the right syntax. The right interface subcommand is: ip access-group 10 in. Also it would not work as intended because it includes the wrong subnet. Please fix answer.
C 2
Selected Answer: C
It would apply the access list, but no traffic will be permitted as the applied IP is incorrect
2
Reread the question: What is the effect of the configuration as the administrator applies the command?
The correct answer is D
Explanation: The configuration commands shown in the exhibit are used to apply an access list to the inbound traffic on interface Serial0 . The access list permits traffic from the 10.0.0.0/24 subnet to the WAN on interface Serial0
B 2
Selected Answer: B
A Stupid question.
B 2
Selected Answer: B
Should be 'ip access-group', not 'access-list'
2
The answer is D
2
with vty lines
ip access-class is used for ipv6 access list, and access-class alone is used for ipv4 access lists.
C 1
Selected Answer: C
Yeah i agree, 'C" is the correct answer.
C 1
Selected Answer: C
The correct answer is C
C 1
Selected Answer: C
C is correct
1
Spoto says the answer is "D" for this question :)))))
1
Spoto says "D" is answer for this question, which one is true? :)))))))
D 1
Selected Answer: D
B. The permit command fails and returns an error code: wrong everything is correct about this config
C. The router fails to apply the access list to the interface: wrong as you can see he does actually apply the acl on the interface
D. The sourced traffic from IP range 10.0.0.0 - 10.0.0.255 is allowed on Serial0: correct, it may be not what he wanted to do but is the only correct anwer
1
ACL apply command is fail. The command is must be <ip access-group 10 in>
C 1
Selected Answer: C
- - use the "ip access-group" command at the interface level, not "ip access-list"
1
access-list, access-group and access-class