Q20Network Fundamentals
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
← → navigate · a answer
Discussion · 3
25
(config)#lldp ?
holdtime Specify the holdtime (in sec) to be sent in packets
reinit Delay (in sec) for LLDP initialization on any interface
run Enable LLDP
timer Specify the rate at which LLDP packets are sent (in sec)
tlv-select Selection of LLDP TLVs to send
17
lldp reinit
Specifies the delay time in seconds for LLDP to initialize on any interface.
The range is 1 to 10 seconds; the default is 2 seconds.
4
C is correct